Clifford concept 50 Bedienungsanleitung PDF herunterladen (Seite 13)

To exit valet mode

1. Turn the ignition switch to its “ON” position or start the engine.

2. Flick the switch back to its centre position. The LED will turn off to confirm that

the system is now in its normal operating mode.

Setting your own secret valet code

Since all Concept 50 systems have the same factory-set code, it is highly advisable

that you set your own valet code. You may choose any 1-, 2-, or 3-digit code that

does not have any zeros. You can also change the code whenever you want.

1. Write down the 1-to-3 digit code you wish to use (remember, no zeros in the code).

2. Turn your vehicle’s ignition switch to its “ON” position.

3. Enter your

current valet code (if setting a new code for the first time, enter the

factory-set code of “2” by tapping the momentary side of the switch twice, then

pressing the latched side).

4. When the LED turns on, immediately tap and release the momentary side of the

switch 6 times (after the first three taps, you will hear a single chirp confirmation

each time you tap the momentary side — in this case for a total of 3 chirps).

5. Immediately after the 3rd chirp, press the latched side, then enter your new code.

You’ll hear the same number of chirps as each digit of your code each time you

press the latched side. When done, return the switch to its centre position. Wait

until you hear 2 chirps and see the LED turn off, then turn the ignition off.

6. VERY IMPORTANT

You must test your new valet code. Wait at least 10

seconds, then turn on the ignition and re-enter your new code. The LED should

turn on. Return the switch to its centre position. NOTE: If the LED does not

illuminate, your new code was entered incorrectly. The system has

AUTOMATICALLY REVERTED TO THE PREVIOUS VALET CODE.

Example: Let’s say you want to change the code from its original single-digit

“2” code to a double-digit code of “31.” You would do the following:

Turn the ignition on, enter your current code, tap the momentary side of the

PlainView switch

6 times

, press the

latched

side, then enter the new code:

momentary, momentary, momentary, latched (3 chirps), momentary, latched (1

chirp), centre. Wait for the 2 chirp confirmation and the LED to turn off, then turn

the ignition off. Wait 10 seconds, turn the ignition on and test the new code.

Dual-sensor protection

Concept 50 has both a Glass Tampering Sensor and a Volumetric Radar Sensor. The

Glass Tampering Sensor detects attempts to break any of the vehicle’s windows.

For improved sensitivity in vans and other large vehicles, your installer can add a

second miniature microphone. The Volumetric Radar Sensor detects anyone leaning

into the passenger compartment, so it will protect your car even if it’s a convertible

or soft-top, or if you happen to leave the window(s) open. Unlike ultrasonic sensors,

the Volumetric Radar Sensor is impervious to wind and temperature variations.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

Kommentare zu diesen Handbüchern

Keine Kommentare

Clifford concept 50 Bedienungsanleitung Seite 13

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Auto Alarmanlage Clifford concept 50