Clifford SmartWindows 4 Bedienungsanleitung PDF herunterladen (Seite 14)

System Checklist & Troubleshooting (Continued)

Step 14.

Test the AutoArming By pass fea ture.

Disarm the system. Turn the ignition to the “ON” position, then turn the ignition “OFF.”

One Chirp. This is the correct response, wait 30 seconds after the interior lights have turned off to insure the system does not

passively arm. Proceed to step 15.

Step 15.

Test remote control range.

Stand approximately 100 feet from the vehicle and use the remote control to arm and disarm the syst em.

The Concept 100 will re spond with the pre vi ously noted in di ca tions for arm ing and dis arm in g. If not:

o Re po si tion the antenna as high up as possible un der the dash or on the windshield and as far as pos si ble from heavy

wire looms and metal. Rotate the extended range receiver 90 degrees and re-test.

o Make sure that the re mote con trol bat tery meas ures at least 3 volts while trans mit ting.

o Make sure that the volt age at the con trol unit be tween the 5A fused power line and each of the t wo ground lines meas ures

at least 12.0 volts (if less, make sure both chas sis grounds are solid; if the grounds are solid, the ve hi cle battery may need

charg ing, serv ic ing or re place ment).

Step 16.

Dis trib ute all nec es sary pa per work in clud ing:

User’s Manual must be given to the customer.

Adhere the Clifford window decals to the vehicle’s windows after discussing placement with the vehi cle owner.

Step 17.

Dem on strate Ba sic Sys tem Op era tion:

Remote control operation:

o Arming/disarming and locking/unlocking

o Remote Valet Mode Activation

o Panic feature

o Accessory Activation

AutoArming and AutoArming Bypass

Immobilisation

Valet code entry

User-programming mode

14 Con cept 100/199

1 2 ... 9 10 11 12 13 14

Keine Kommentare

Clifford SmartWindows 4 Bedienungsanleitung Seite 14