Clifford SmartWindows 4 Installationsanleitung PDF herunterladen (Seite 13)

11. Click done.

12. Click OK to save and exit or Apply to save and test/adjust vent duration.

IIff uussiinngg SSmmaarrttWWiinnddoowwss 44 IINNSSTTEEAADD OOFF tthhee ssyysstteemm’’ss wwiinnddooww rroolllluupp eelleeccttrroonniiccss::

Install the SmartWindows 4 module(s). When installation is complete:

1. Plug the Wizard cable into any available 3-pin DataPort connection in the instal-

lation (on SmartWindows 4, for example).

2. Launch the CliffNet Wizard PRO program.

3. Click the Install icon button at the top of the screen.

4. Make sure the check box next to the Program Windows button indicates

disabled, then click the Program Windows button. This will disable the system’s

built-in window roll-up electronics. If you do not do this, there will be a 7-second

delay after arming until SmartWindows 4 activates.

5. Click OK.

6. Click the Windows icon button at the top of the screen.

7. Turn ignition on and roll down all windows.

8. Click the Enter Program Mode button.

9. Hold one of the window switches “up” for about 2 seconds, then release (the

switch must be connected to SmartWindows 4). The window should move

immediately when you hit the switch.

10. Allow the windows to finish their programming cycle. This should take about 2

minutes and is indicated as complete when both windows vent slightly.

11. If you have another SmartWindows 4 to program, select ID2 from scroll bar at

top and repeat steps #7-11. Otherwise, go to next step.

12. Click done.

13. Click OK to save and exit or Apply to save and test/adjust vent duration.

1 2 ... 8 9 10 11 12 13 14 15

Keine Kommentare

Clifford SmartWindows 4 Installationsanleitung Seite 13