© 2005 directed electronics—all rights reserved
7
this wire.
b. Connect the BLUE wire to the motor side of the cut wire and the
WHITE/BLUE wire to the switch side.
5. Find the wire that shows 12V while pressing the driver’s window switch as if roll
ing the window down on the driver’s side.
a. If the voltmeter reads 12V while pressing DOWN side of the switch, cut this
wire.
b. Connect the ORANGE wire to the window motor side of the cut line and
the WHITE/ORANGE wire to the switch side.
b. Connect the GRAY wire to the motor side of the switch and the
WHITE/GRAY wire to the passenger’s switch side of the cut line.
6. Go to the passenger’s side window switch wires and find the wire that shows 12v
while pressing the passenger’s window switch as if rolling the window up.
a. If the voltmeter reads 12V while pressing the “UP” side of the switch, cut
this wire.
7. Find the wire that shows 12V while pressing the window switch as if rolling the
window down on the passenger’s window.
a. If the voltmeter reads 12V while pressing DOWN side of the switch, cut this
wire.
b. Connect the VIOLET wire to the window motor side of the cut line and the
WHITE/VIOLET wire to the switch side.
NNOOTTEE::
If the vehicle has power window switches only on the center console (no door
switches), you may make the appropriate connections at the switch. If there are door
switches, you must make the connections at each motor.
Program the Windows
1. Use the programming grid in the Installer-Programmable Features section in the
installation manual for the security system you are installing to program
SmartWindows 4. Make sure both windows are rolled down before you begin
programming.
2. Turn the ignition ON.
3. Select the appropriate row/column from the installer programming grid, the
siren will chirp twice. Press and hold the driver’s window switch “UP” for approx-
imately two seconds.
Kommentare zu diesen Handbüchern