www.directed.com
6
b. Connect the ORANGE wire to the motor side of the cut wire and the
WHITE/ORANGE wire to the switch side.
5. Find the wire that shows 12V while pressing the driver’s window switch as if
rolling the window down on the driver’s side.
a. If the voltmeter reads 12 volts while pressing DOWN side of the switch, cut
this wire.
b. Connect the BLUE wire to the window motor side of the cut line and the
WHITE/BLUE wire to the switch side.
6. Go to the passenger’s side window switch wires and find the wire that shows
12V while pressing the passenger’s window switch as if rolling the window up.
a. If the voltmeter reads 12V while pressing the “UP” side of the switch, cut
this wire.
b. Connect the VIOLET wire to the motor side of the switch and the
WHITE/VIOLET wire to the passenger ’s switch side.
7. Find the wire that shows 12V while pressing the passenger window switch as if
rolling the window down on the passenger window.
a. If the voltmeter reads 12 volts while pressing DOWN side of the switch, cut
this wire.
b. Connect the GRAY wire to the window motor side of the cut line and the
WHITE/GRAY wire to the switch side.
NNOOTTEE::
If the vehicle has power window switches only on the center console (no door
switches), you may make the appropriate connections at the switch. If there are door
switches, you must make the connections at each motor.
Motor/Switch Connections - Negative Switches
1. Make sure the ignition switch is turned to the “ON” position.
2. Access the wires at the window motor.
3. Connect the negative voltmeter lead to 12V.
4. Connect the other voltmeter lead to a wire at the driver’s side window motor and
find the wire that shows 12V while pressing the driver’s window switch as if
rolling the window up.
a. If the voltmeter reads 12V while pressing the “UP” side of the switch, cut
Kommentare zu diesen Handbüchern