Clifford SmartWindows 4 Installationsanleitung PDF herunterladen (Seite 8)

www.directed.com

4. Release the switch and allow the window to roll up. After the window reaches

the top, it will pause. It will then automatically complete programming by rolling

both windows up/down several times.

5. Programming is complete when both windows vent. You may then turn off the

key to exit programming or if you have a second set of SmartWindows 4

installed, touch and release the driver’s window UP for the second set of

windows. It will follow the same process as the first set you programmed. If the

programming doesn’t complete successfully, start over from step #1.

Memory is nonvolatile and will NOT have to be reprogrammed in the event of a

power loss.

To fine tune the vent or to program the windows without using the valet switch, use the

CliffNet Wizard Pro.

window control

If the windows can be closed using a key in the door of the car, see section 1 below.

If the windows cannot be closed using a key in the door and the alarm you are

installing has built-in window roll up, see section 2 below.

section 1—automatic window/sunroof closure

NNOOTTEE::

This requires the use of an optional relay.

If the door key can close the power windows/sunroof, you can make them automati-

cally close upon remote arming.

1. Find the wire that shows either +12V or (-) when the key is held at the lock

position in the door cylinder.

2. Tap a wire in to this wire and connect to terminal 30 of the optional relay.

3. If the wire shows (-) when the key is turned, connect terminal 87 to (-). If the wire

shows +12V when the key is turned, connect terminal 87 to 12V.

4. Connect the output of the alarm that can be set to AutoActivate to terminal 85.

5. Connect +12V to terminal 86.

6. Turn on the “AutoActivate timed accessory upon remote arming” feature as

noted in the installation manual for the alarm under the

Programmable Features

section.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

Keine Kommentare

Clifford SmartWindows 4 Installationsanleitung Seite 8